Slayer · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR is a direct descendant of the JCM800 2203 voicing. Bridge ProBucker, mids pushed, reverb off, master up for power-tube push. Tight gain rather than max saturation for palm-mute clarity.
Less front-end push and a less sculpted mid-hump than the record.
Workaround: Set Middle 8 and leave the Tone Shift button out; gain_ultra 6 covers the extra drive.
Hiss and feedback between chugged bursts at high gain.
Workaround: Mute with the picking-hand palm and left-hand fingers; roll bridge volume down between sections.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings