Slayer · settings for Epiphone Les Paul Standard + Fender '65 Deluxe Reverb Reissue
At zero: Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A 22W blackface Deluxe Reverb with no drive pedals can't reach JCM800 thrash saturation. Best available: bridge ProBucker into the Normal channel pushed to the edge of breakup, bright and mid-forward, reverb off and dry. Expect gritty crunch, not Reign in Blood.
Without a mid-humped boost the amp never saturates or gets the upper-mid bite; the riff sounds clean and thin.
Workaround: Run volume 8 with bridge pickup full up and dig in hard; treble 6 / bass 3.5 approximates the mid-forward curve.
High-gain hiss and ringing between tremolo bursts stays audible.
Workaround: Mute with the picking-hand palm and fret-hand fingers between bursts; at this low gain noise is minimal anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Fender '65 Deluxe Reverb Reissue.
Fender '65 Deluxe Reverb Reissue settings