Slayer · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
You own the actual amp. Plug the Les Paul bridge humbucker into the High input, push the pre-amp hard, keep mids up and no reverb. Without the Boss 10-band you lose some front-end push, so lean on the pre-amp and master.
Less mid punch and front-end saturation; riff sits slightly flatter and softer.
Workaround: Push Middle to 8 and pre-amp to 8.5 on the High input to mimic the mid-hump and extra gain.
Hiss and feedback fill the gaps between tremolo bursts.
Workaround: Mute with the picking-hand palm and left-hand fingers; roll bridge volume off between sections.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
B.C. Rich (Bich/Mockingbird) with DiMarzio Super Distortion, bridge pickup → Boss 10-band graphic EQ (mid-boosted) → Noise gate → Marshall JCM800 2203 head → Marshall 1960 4x12 cabinet
The notes are simple, but the riff demands clean, even tremolo picking and disciplined muting for the full section without the right hand tiring or the tone washing out.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings