Van Halen · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
Phaser type, slow rate ~9-10 o'clock, moderate depth.
2-3 repeats, low level.
Room/plate, very low level.
Brown sound on a 20W modeler: OD1 voice with ISF toward British for Marshall mids, bridge ProBucker full up, built-in phaser slow and a short slapback delay. No pedals needed; all gain from the amp voice.
Closing low Eb harmonic lacks the warbling, pitch-smeared tape growl.
Workaround: Use the built-in delay with more repeats and ride the whammy/volume for the dive effect.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Single bridge humbucker (only pickup on the guitar)
Frankenstrat (rewound Gibson PAF) → MXR M-117 Flanger (likely off) → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo → 1968 Marshall 1959 Super Lead 100W (variac-fed) → Marshall 4x12 with Celestion Greenbacks → Sunset Sound echo chamber/plate (mix)
The signature tapped arpeggios, dive bombs and picked bursts demand elite technique, and the tone relies on extreme amp volume and feedback control rather than pedals.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings