Van Halen · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
At zero: Booster · Fx
Phaser, rate approx 9-10 o'clock (slow), depth moderate.
Analog/tape delay, ~250 ms, 2-3 repeats, level low.
Room/plate, short decay, level low.
Katana's Brown mode is literally modeled on the variac'd Plexi, so this is a close match. Bridge ProBucker full up, phaser in the Mod block, short tape slapback in Delay, light room reverb for the Sunset Sound ambience.
The final low Eb harmonic lacks the warbling tape-motor dive.
Workaround: Fake it with a slow whammy-bar drop into the last note while the delay repeats ring.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Single bridge humbucker (only pickup on the guitar)
Frankenstrat (rewound Gibson PAF) → MXR M-117 Flanger (likely off) → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo → 1968 Marshall 1959 Super Lead 100W (variac-fed) → Marshall 4x12 with Celestion Greenbacks → Sunset Sound echo chamber/plate (mix)
The signature tapped arpeggios, dive bombs and picked bursts demand elite technique, and the tone relies on extreme amp volume and feedback control rather than pedals.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings