Van Halen · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 2203 through the High input is already most of the way to a cranked Plexi. Run the bridge ProBucker wide open, mids pushed, preamp high but not maxed, and lean on volume and pick attack for the brown-sound saturation.
Loses the slow swirl that thickens the tapping section.
Workaround: Play it dry; emphasize vibrato and volume swells for movement instead.
No short tape slapback or preamp sheen; tone sounds drier and flatter.
Workaround: Use the amp's FX loop later with any delay; for now rely on room volume for ambience.
The growling, warbly closing low-note dive loses its lo-fi tail.
Workaround: Do the final dive with the bar alone and let the amp feed back.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Single bridge humbucker (only pickup on the guitar)
Frankenstrat (rewound Gibson PAF) → MXR M-117 Flanger (likely off) → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo → 1968 Marshall 1959 Super Lead 100W (variac-fed) → Marshall 4x12 with Celestion Greenbacks → Sunset Sound echo chamber/plate (mix)
The signature tapped arpeggios, dive bombs and picked bursts demand elite technique, and the tone relies on extreme amp volume and feedback control rather than pedals.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings