Van Halen · settings for Epiphone Les Paul Standard + Marshall MG30GFX
Slow rate, roughly 9-10 o'clock.
~250 ms slapback, 2-3 repeats, low mix.
Eddie's cranked Plexi through a 30W solid-state MG30: use OD1 for saturated-but-tight brown-sound crunch, bridge ProBucker full up, the amp's built-in phaser for the slow swirl and a short slapback delay. No reverb beyond a hint of room.
No tape preamp boost, wow/flutter, or end-of-track pitch dive
Workaround: Use the amp's digital delay short and quiet; do the final dive with the fingers and bends
Amp phaser is thinner and less mid-humped than the script 90
Workaround: Keep FX Level low so the swirl sits under the note, not on top
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Single bridge humbucker (only pickup on the guitar)
Frankenstrat (rewound Gibson PAF) → MXR M-117 Flanger (likely off) → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo → 1968 Marshall 1959 Super Lead 100W (variac-fed) → Marshall 4x12 with Celestion Greenbacks → Sunset Sound echo chamber/plate (mix)
The signature tapped arpeggios, dive bombs and picked bursts demand elite technique, and the tone relies on extreme amp volume and feedback control rather than pedals.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings