Van Halen · settings for Epiphone Les Paul Standard + Yamaha THR10II
Slow sweep, low depth via Effect knob at 3.
~250 ms, 2-3 repeats, low mix via Echo/Reverb at 2.5.
Eruption's cranked Plexi via a THR10II: Lead mode with high gain, bridge ProBucker full up, built-in phaser for the slow Phase 90 swirl and a short slapback delay. No pedals needed; the missing ingredient is sheer power-tube volume and feedback.
Loses the tape compression, brightness boost and the final note's motor dive
Workaround: Use the THR delay for slapback and do the final dive with the whammy or pitch bend by hand
Final low harmonic lacks the cheap growling runaway echo
Workaround: Briefly raise Echo/Reverb for the closing note
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Single bridge humbucker (only pickup on the guitar)
Frankenstrat (rewound Gibson PAF) → MXR M-117 Flanger (likely off) → MXR Phase 90 → Maestro Echoplex EP-3 → Univox EC-80A tape echo → 1968 Marshall 1959 Super Lead 100W (variac-fed) → Marshall 4x12 with Celestion Greenbacks → Sunset Sound echo chamber/plate (mix)
The signature tapped arpeggios, dive bombs and picked bursts demand elite technique, and the tone relies on extreme amp volume and feedback control rather than pedals.