Audioslave · settings for Squier Stratocaster + Boss Katana (50/100 MkII, Gen 3)
Pitch Shifter / Harmonist, +2 octaves (+24 semitones), 100% wet, no dry.
Feedback low (2-3 repeats), level low.
Plate or Hall, short-medium decay, low level.
Mid Boost / Treble Booster, low level, +3dB feel.
Katana's Crunch mode gives the JCM800 mid-forward crunch; bridge single-coil needs extra gain to match the Hot Rails. The Whammy octave-up is the signature and must be covered by the Fx block's pitch shifter, with delay from the Delay section.
Without a foot-swept pitch pedal you get a static octave-up, losing the scooping siren glides
Workaround: Use the Katana Fx pitch shifter at +24 semitones full wet and create movement with slides and vibrato on the low E
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings