Audioslave · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume
Classic channel reverb.
DSL40CR Classic channel in Crunch gets you very close to the JCM800 overdrive voice. Bridge single-coil needs a bit more gain and a slight mid push to compensate for the thin ceramic pickup. No Whammy means the octave-up scream is the one unfixable gap.
The solo's entire signature screaming octave-up voice is absent; you only get the low G minor line.
Workaround: Play the same line two octaves higher on the high strings with full sustain, bending into notes to mimic the Whammy sweep.
Loses the trailing repeats that give the lead depth behind the octave voice.
Workaround: Lean on the amp reverb and longer sustained note phrasing for space.
Slightly less volume/mid lift going into the solo.
Workaround: Set amp mids at 6.5 and keep guitar volume at 10 for the lead.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings