Audioslave · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
Your 2203 is the same Marshall crunch family as Morello's 2205, so the amp half is near-perfect. Push the preamp a bit higher to compensate for low-output ceramic single-coils, and keep mids forward. The octave-up Whammy scream cannot be faked without a pedal.
The solo's defining synthetic octave-up scream is simply absent; you get a plain crunch lead.
Workaround: Play the G minor line two octaves higher on the top strings with heavy vibrato and full sustain to imply the pitch, bending into notes to mimic the pedal sweep.
Lead notes sound dry and small without trailing repeats.
Workaround: Let notes ring fully and use the room; keep master loud so the amp and room give natural bloom.
Slightly less mid push and volume lift into the preamp.
Workaround: Raise the amp Middle to 6.5-7 and keep guitar volume at 10 for the same mid-forward lift.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings