Audioslave · settings for Squier Stratocaster + Marshall CODE 25
Octave/pitch shift +2 octaves (+24), mix 100% wet.
Feedback low (2-3 repeats), level ~25%.
Large hall/plate, level ~20%.
JCM800 2203 model on the CODE 25, bridge single-coil, moderate crunch. The amp's pitch block stands in for the Whammy two octaves up, with delay and a touch of reverb for the studio ambience.
Without a foot-swept pitch pedal you get a static two-octave voice instead of the rising scream
Workaround: Use the amp's fixed +2 octave pitch block and create motion with slides and bends on the low E
Slightly less mid-lift and volume jump into the solo
Workaround: Middle set to 7 and gain at 7 supply the same mid-forward lift
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Marshall CODE 25.
Marshall CODE 25 settings