Audioslave · settings for Squier Stratocaster + Marshall MG30GFX
Marshall MG30GFX on Crunch gives the JCM800-ish mid-forward crunch; low-output ceramic single-coils need more gain than Morello's Hot Rails. Built-in delay covers the trailing repeats and a touch of reverb for studio ambience. The octave-up Whammy scream cannot be reproduced without a pitch pedal.
The solo's signature synthetic octave-up scream is absent; you only hear the dry crunch line.
Workaround: Play the same G minor phrases two octaves higher on the top strings with full sustain and wide vibrato to imply the pitch.
Slightly less volume lift and mid push entering the solo.
Workaround: Raise amp Middle and channel Volume a notch for the lead section.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings