Audioslave · settings for Squier Stratocaster + Fender Frontman 10G
No effects needed for this part.
Frontman 10G overdrive channel with bridge single-coil gets a thin approximation of Morello's JCM800 crunch. The signature two-octave Whammy scream can't be reproduced without a pitch pedal, so the solo becomes a plain sustained lead line.
The solo's defining synthetic octave-up scream is simply absent; you hear only the dry low-E line.
Workaround: Play the same melody two octaves higher on the high-E and B strings for the pitch content, accepting no pitch-sweep effect.
Sustained notes die quickly with no trailing repeats, so the lead sounds dry and small.
Workaround: Hold notes longer and use vibrato to fake sustain; stand closer to the amp for feedback.
No mid-push volume lift into the amp, so the lead doesn't jump forward.
Workaround: Run amp gain and volume slightly higher for the solo since no level change is available.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings