Audioslave · settings for Squier Stratocaster + Line 6 Helix Floor (direct)
Tames single-coil hum under gain.
800Hz +3dB, low cut 80Hz - mid/volume lift.
Mode 2 Octave Up, Mix 100% wet, expression pedal heel-to-toe per note.
Ch Vol to taste.
Mic 57 Dynamic, distance 2", low cut 90Hz, high cut 7.5kHz.
Stands in for studio reverb.
Helix direct: Brit 2204 (JCM800) crunch with a 4x12 cab, EQ boost in front, Pitch block two octaves up, tape delay ~400ms and a touch of plate reverb to replace the studio ambience. Bridge pickup, volume full.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets