Audioslave · settings for Squier Stratocaster + Fender Hot Rod Deluxe IV
Marshall-style crunch lead approximated on the Hot Rod Deluxe Drive channel with bridge single-coil. Mids pushed, treble pulled back for the bright ceramic pickup, light amp reverb for the studio ambience. No Whammy means the signature octave-up scream is the big gap.
Without it the solo loses its entire synthetic octave-up scream identity.
Workaround: Play the lines two octaves higher on the top strings with heavy vibrato and full sustain.
Lead loses its trailing repeats and depth behind the sustained notes.
Workaround: Lean on amp reverb and longer sustained note held into the next phrase.
Slightly less mid push and volume lift into the solo.
Workaround: Middle set high on the amp already supplies the mid-forward lift.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge Hot Rails humbucker for the solo (neck for clean verse)
Soul Power Stratocaster (bridge Hot Rails) → DOD FX40B EQ (boost) → DigiTech WH-1 Whammy (2 octaves up) → BOSS DD-3 Digital Delay → Marshall JCM800 2205 overdrive channel → Peavey 4x12 cabinet → studio reverb on the recorded track
The notes themselves are simple G minor low-E string lines, but the tone depends almost entirely on precise Whammy pedal footwork and rapid pickup-selector/killswitch chops, which are hard to time cleanly.
Every song already dialed in for the Fender Hot Rod Deluxe IV.
Fender Hot Rod Deluxe IV settings