Periphery · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
Room/plate type, level ~1.5/10.
Drop C djent chug on a Les Paul into the ID:Core: OD2 voice, bridge humbucker, ISF slightly American for scoop with enough treble for pick attack. No gate or screamer on hand, so right-hand muting does the tightening.
Low end stays looser and the amp is less focused on palm mutes.
Workaround: Roll amp gain to 6, bass to 4 and pick closer to the bridge for tightness.
Hum and string noise bleed into the gaps between staccato chugs.
Workaround: Mute with the palm and fretting-hand fingers immediately after each hit.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings