Periphery · settings for Epiphone Les Paul Standard + Yamaha THR10II
Hall/Spring type, level low via echo_rev at 2.
Modern djent chug on a THR10II: Hi Gain mode, bridge ProBucker, tight mids and controlled bass with a touch of reverb. No overdrive pedal, so gain stays moderate and your palm mute does the tightening.
Low end stays looser and the amp model is less focused on fast chugs.
Workaround: Lower amp bass to 4 and roll bridge tone to 8; mute aggressively at the bridge.
Chug gaps ring and hiss instead of being dead silent.
Workaround: Mute with the palm and fretting hand between hits; keep gain at 6.5 rather than maxed.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.