Periphery · settings for Epiphone Les Paul Standard + Fender Blues Junior IV
A Blues Junior with no drive pedals can't reach djent saturation. Best approach: bridge ProBucker, Fat switch on, Volume pushed for maximum tube grit, Master controlled, bright-but-tight EQ. Expect a thick crunch, not modern high-gain.
Without it the amp never reaches tight high gain; chugs stay loose and clean-ish
Workaround: Max bridge volume, amp Volume 8.5+, hard picking for the dirtiest edge available
Chug gaps ring out instead of going silent, blurring the syncopation
Workaround: Mute with the picking-hand palm and fretting-hand damping between hits
Clean lead-in figures lose depth
Workaround: Lean on the amp reverb slightly higher during clean figures
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Fender Blues Junior IV.
Fender Blues Junior IV settings