Periphery · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Periphery's Axe-Fx djent chug on a 10W solid-state practice amp: bridge ProBucker, overdrive switch on, gain high, bass pulled back and treble up to fake the scooped-mid tightness. Expect fizz instead of studio tightness, but the percussive attack survives.
Without a low-cut boost in front, the amp's distortion stays loose and fizzy on drop-C chugs.
Workaround: Roll amp bass to 3-3.5 and keep guitar volume full; pick near the bridge to tighten the attack.
High-gain staccato riffing rings and hisses between hits, blurring the syncopation.
Workaround: Mute with the palm and fretting-hand fingers; lift pressure immediately after each chug.
Clean lead-in figures lose the dotted-eighth depth, sounding flat and dry.
Workaround: Let clean chords ring longer and use neck pickup with tone rolled back for width.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings