Periphery · settings for Epiphone Les Paul Standard + Fender Champion 20
FX select on reverb, FX Level 1.5.
Drop-C djent chug on a Champion 20: Metal voicing, bridge ProBucker, gain backed off so the small solid-state power section stays tight. A touch of built-in reverb only; muting does the rest.
Without it the low chugs lose focus and the amp sounds looser and darker.
Workaround: Keep amp bass at 4 and gain at 6, roll guitar tone to 8, and palm-mute hard for attack.
Staccato gaps ring with hiss and string noise instead of going dead silent.
Workaround: Mute with the right-hand palm and left-hand fingers immediately after each hit; back gain to 5 if noise is bad.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Fender Champion 20.
Fender Champion 20 settings