Periphery · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Drop C djent rhythm on a Les Paul into the DSL40CR: Ultra Gain OD1, mids kept present, tight bass, bridge ProBucker wide open. No tube screamer or gate on hand, so gain stays moderate and right-hand muting does the tightening.
Low end stays looser and the riff lacks the sharp, compressed djent attack.
Workaround: Roll bass back to 4 and keep Ultra gain at 6 so the preamp stays tight; mute hard at the bridge.
Hiss and string noise bleed into the silences between staccato chugs.
Workaround: Palm-mute and damp idle strings with the fretting hand; keep gain no higher than 6.
Clean lead-in figures sound drier and less spacious.
Workaround: Nudge amp reverb up slightly for the clean passages only.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings