Periphery · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
A JCM800 can't fully do an Axe-Fx djent tone, but cranked on the High input with medium-output humbuckers it gets tight, mid-forward Drop C chug. Bridge pickup, gain high, bass pulled back to keep palm mutes percussive.
Without it the low C chugs lose tightness and the amp sounds looser and darker than the record.
Workaround: Set bass to 4, preamp 8.5 and pick closer to the bridge; mute hard with the palm to fake the tightness.
Cranked JCM800 hiss and string noise bleed into the silences between staccato chugs.
Workaround: Mute with the palm and fretting-hand fingers immediately after each hit; keep guitar volume at 10 and hands quiet.
Clean lead-in figures sound dry and flat compared to the album's ambience.
Workaround: Let open strings ring and use the neck pickup with tone rolled back for depth.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings