Periphery · settings for Epiphone Les Paul Standard + Vox AC30C2
At zero: Volume · Tremolo Speed · Tremolo Depth
An AC30 with no drive pedals can't reach modern djent saturation. Best approach: Top Boost channel pushed into its own crunch, bridge ProBucker, tight EQ with Tone Cut taming fizz. Expect a cranked British crunch rather than a scooped Axe-Fx chug.
Without it the AC30 stays loose and under-saturated; no tight djent low end.
Workaround: Crank Top Boost volume past noon and pick hard near the bridge; roll guitar tone to 7 for focus.
Staccato gaps ring and hum at high volume, blurring the syncopation.
Workaround: Mute with the palm and left-hand fingers between hits; kill strings immediately after each chug.
Clean lead-in figures lose the dotted-eighth depth.
Workaround: Lean on the amp reverb for space during clean figures.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker for the riff; neck for clean arpeggio passages
Jackson Custom Shop 6-string with Bare Knuckle humbuckers → Noise gate → Screamer-style overdrive (Axe-Fx block) → Fractal Audio Axe-Fx II high-gain amp model → Digital delay → Reverb block → 4x12 impulse response (direct to DAW)
Amp effects: reverb (Axe-Fx II reverb block, small/plate-style and subtle; modeled unit, so 'amp reverb' is really an effects block)
The hook riff relies on precise rhythmic placement and muting rather than raw speed; sloppy right hand ruins the groove.