Pink Floyd · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
2-3 repeats, level 25-30%.
Chorus, slow rate, shallow depth, low level.
Gilmour's PULSE solo fuzz on a Les Paul into the ID:Core 20: OD2 voice with British-leaning ISF for singing mid sustain, plus built-in delay and a touch of chorus. Bridge humbucker, tone rolled back slightly.
Amp OD2 is tighter and less compressed than true fuzz bloom.
Workaround: Max amp gain in OD2, pick softly and let notes bloom; roll guitar tone to 7.
Less even picking response and shorter note bloom.
Workaround: Pick nearer the neck with consistent attack and use vibrato to keep notes alive.
No extra mid push for the loudest climax phrases.
Workaround: Push ISF higher and dig in harder on the climax licks.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings