Pink Floyd · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume
Gilmour's PULSE outro lead on a Les Paul into a DSL40CR: Ultra channel OD1 for thick singing sustain, bridge humbucker with tone rolled back, mids pushed for the EMG-SPC vocal honk. No pedals, so delay and fuzz bloom are approximated by amp gain and a touch of reverb.
Loses the compressed, vocal fuzz bloom; amp gain is grainier and more mid-forward.
Workaround: Ultra OD1 at gain 6.5 with mids up and guitar tone at 7 gets close in saturation and sustain.
Phrases sound dry and small without the trailing quarter-note repeats.
Workaround: Leave amp reverb at 3 and let notes ring longer to imply space.
Picking dynamics less even; long notes bloom less.
Workaround: Pick evenly near the neck pickup and use vibrato to keep notes alive.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings