Pink Floyd · settings for Epiphone Les Paul Standard + Marshall MG30GFX
2-3 repeats, level modest via FX Level 4.
Slow rate, shallow depth.
Gilmour's PULSE outro solo on a Les Paul through the MG30: OD1 for thick singing sustain, mids pushed, amp delay for trailing repeats and a touch of chorus for width. Bridge humbucker with tone rolled back for vocal bloom.
Amp OD1 is tighter and grainier than the Muff's compressed, blooming fuzz sustain.
Workaround: Max mids, gain 7.5 and roll bridge tone to 7; play hard and let notes bloom into feedback.
Less even picking response and shorter sustain on long bends.
Workaround: Pick with consistent attack and use amp gain plus volume for natural sustain.
No extra midrange push for the loudest climax phrases.
Workaround: Boost the amp Middle knob and dig in harder for the final licks.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings