Pink Floyd · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Gilmour's PULSE outro lead on a Les Paul into a 10W Frontman: use the overdrive channel near max gain for compressed sustain, bridge humbucker with tone rolled back for the vocal, mid-focused voice. No fuzz, delay or chorus available, so sustain and phrasing carry the tone.
Without it the lead loses its thick, singing fuzz bloom; amp overdrive is thinner and grainier.
Workaround: Run amp gain 8.5 with bridge pickup full volume and tone at 6-7; let notes bloom with vibrato instead of picking hard.
Phrases sound dry and small; the signature spacious trailing repeats are absent.
Workaround: Play phrases slightly longer and let notes ring into each other to imply the repeats.
Picking dynamics are less even and long notes decay sooner.
Workaround: Pick with consistent moderate attack and use continuous vibrato to sustain.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings