Pink Floyd · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
No fuzz available, so the JCM800's High input carries the lead: high preamp for thick saturation, bridge humbucker with tone rolled back to mimic the Muff's dark vocal sustain. Delay, chorus and compression are absent and must be faked with phrasing and volume.
Loses the compressed, singing fuzz sustain that defines this solo; JCM800 gain is tighter and grittier.
Workaround: Run High input with preamp near 9, master loud, tone knob at 6-7, and pick softly near the neck for bloom.
Phrases sound dry and small without the trailing quarter-note repeats.
Workaround: Leave space after phrases and let notes ring; sustain substitutes for repeats.
Picking dynamics less even, notes bloom less.
Workaround: Amp saturation at high preamp compresses naturally; pick with consistent attack.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings