Pink Floyd · settings for Epiphone Les Paul Standard + Boss GX-100 (direct)
Evens bends.
Mid push, tames harshness.
Level to taste.
+3dB at 1kHz, -2dB at 300Hz, low cut 80Hz, high cut 6kHz.
Low mix.
Feedback 25 (2-3 repeats), Level 28%.
Stands in for the arena.
Celestion-style 4x12, dynamic mic, slight off-axis.
PULSE outro lead rebuilt entirely in the GX-100 going direct: Brit Stack clean-ish platform, Muff Fuzz for the singing fuzz sustain, compressor, chorus and ~440ms delay. Humbuckers are darker than EMGs, so EQ shifts upper-mids back in.
Loses the slow rotary swirl around the dry tone in the stereo field.
Workaround: Set the Chorus block slightly deeper and run stereo outputs for width.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.