Pink Floyd · settings for Epiphone Les Paul Standard + Marshall CODE 25
Level to match clean volume.
Moderate amount, slow attack feel.
Rate slow (~20%), Depth ~30%, Mix low.
Feedback 2-3 repeats, Level 25-30%.
Humbucker Les Paul into a CODE 25: JCM800 model with the built-in distortion block standing in for the Big Muff, compressor for bloom, light chorus and a ~440ms delay for the PULSE wash. Neck pickup with tone rolled back fakes the EMG mid push.
Amp distortion block is tighter and less compressed than a Muff's violin-like fuzz sustain.
Workaround: Max the distortion block's drive, lower its tone and push amp middle to fake Muff bloom.
Loses the slow spatial swirl around the dry lead tone.
Workaround: Use the chorus block slightly deeper, or swap to phaser at slow rate for movement.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Marshall CODE 25.
Marshall CODE 25 settings