Pink Floyd · settings for Epiphone Les Paul Standard + Yamaha THR10II
Feedback for 2-3 repeats, mix 25-30%.
Slow rate, shallow depth.
Lead mode on the THR10II pushed hard for a thick fuzz-like sustain, bridge ProBucker with tone rolled back to tame the hotter humbucker. Built-in delay plus a touch of chorus recreate the PULSE wash; no Muff, so sustain comes from amp gain and volume.
Amp gain alone is tighter and less compressed than the blooming fuzz sustain.
Workaround: Max Lead gain, dig in on long notes and use guitar volume for dynamics.
Less even picking response and shorter bloom on sustained bends.
Workaround: Lean on the amp's high gain compression and consistent picking pressure.
No extra mid push for the loudest climax phrases.
Workaround: Raise amp Middle slightly and pick harder at the climax.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.