Pink Floyd · settings for Epiphone Les Paul Standard + Boss Katana (50/100 MkII, Gen 3)
Green/mid-boost type, level low, drive low.
Chorus, rate slow, depth low.
~440 ms, 2-3 repeats, mix 25-30%.
Hall, short, very low mix.
Katana's Lead mode stands in for the Hiwatt/Big Muff lead stack: thick, compressed high-gain sustain with mid push, plus built-in chorus, delay and a touch of reverb for the PULSE stereo wash. Humbuckers need less gain than Gilmour's EMGs.
Amp distortion bites rather than blooms; less compressed vocal fuzz sustain
Workaround: Lead mode with gain 6.5 and booster on, pick softly and let notes sustain
Less even picking dynamics and shorter bloom on long bends
Workaround: Use amp volume and vibrato for sustain; keep picking hand consistent
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+middle for some phrases)
Fender '57 reissue Stratocaster (EMG-SA/SPC/EXG) → Boss CS-2 Compression Sustainer → Big Muff Pi (Sovtek) → Pete Cornish G-2 → Tube Driver 911 → TC Electronic 2290 delay → Boss CE-2 chorus (one amp side) → Alembic F-2B preamp → Hiwatt DR103 power amp → WEM Super Starfinder / Marshall 4x12 cabs + Doppola rotating speakers
Amp effects: chorus (Not an amp circuit, but a Boss CE-2 fed one of the two Hiwatt heads permanently in the stage rig)
The notes are not fast, but the tone depends on perfect bend intonation, slow wide vibrato and control of long sustaining notes at high volume.
Every song already dialed in for the Boss Katana (50/100 MkII, Gen 3).
Boss Katana (50/100 MkII, Gen 3) settings