TOOL · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
Drop-D Vicarious riff on a 20W modeler: OD2 voice, bridge ProBucker, ISF pushed British for Diezel/Marshall mids, gain set for tight saturation rather than mush. No ambience under the main riff.
Less tightening of pick attack and front-end push into saturation.
Workaround: Raise amp gain slightly and roll bass to 5 for a similar tight, compressed attack.
No mid knob, so the low-mid thickening must come from ISF alone.
Workaround: Use ISF 7 and bass 5 to approximate the low-mid bump without boom.
Only affects the sparse opening figure, not the main riff.
Workaround: Leave the built-in delay off; the riff itself is essentially dry.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings