TOOL · settings for Epiphone Les Paul Standard + Fender Frontman 10G
No effects needed for this part.
Drop-D Tool chug on a Frontman 10G: bridge ProBucker into the overdrive channel, treble up, bass moderate so the tiny speaker stays tight. It gets the midrange snarl, not the four-amp wall of low end.
Without a clean boost the front end is less tight and the chug loses attack definition.
Workaround: Pick slightly harder near the bridge and keep guitar volume at 10; roll bass back a touch for tightness.
No mid control on this amp, so you cannot dial the midrange push that defines the riff.
Workaround: Use treble around 6 and bass at 4 to imply a mid-forward voice; avoid scooping.
The sparse opening figure loses a little depth; the main riff barely used it.
Workaround: Let notes ring fully instead of adding ambience.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Fender Frontman 10G.
Fender Frontman 10G settings