TOOL · settings for Epiphone Les Paul Standard + Fender Hot Rod Deluxe IV
1.
Tool's Vicarious is a multi-amp high-gain wall; a Hot Rod Deluxe can only approximate it. Use the More Drive channel with scooped-but-mid-present EQ, bridge ProBucker full up, and tight palm muting to keep definition. A drive pedal would close most of the gap.
Without a boost the HRD's Drive channel stays loose and under-saturated for this riff.
Workaround: Run Drive near 8 with bridge pickup wide open and pick hard; cut bass to recover tightness.
Loses the low-mid thickening that gives the chug its weight.
Workaround: Approximate with Middle at 7 and Bass at 3.5 on the amp.
Opening figure loses a little depth; main riff is largely dry anyway.
Workaround: Leave dry; amp reverb at 1 gives minimal space.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Fender Hot Rod Deluxe IV.
Fender Hot Rod Deluxe IV settings