TOOL · settings for Epiphone Les Paul Standard + Vox AC30C2
At zero: Volume · Reverb · Tremolo Speed · Tremolo Depth
No effects needed for this part.
An AC30 with no pedals can't reach Diezel high-gain, so we push the Top Boost channel into its loudest natural crunch, darken the top with Tone Cut, and use the bridge ProBucker full-out for maximum thickness in drop D.
Without a clean boost the AC30 never reaches the saturation and tight attack of the record; the riff stays crunchy rather than heavy.
Workaround: Run Volume (Top Boost) at 8.5+ with the guitar volume full and pick hard; keep Tone Cut up to control resulting fizz.
The AC30 lacks the low/low-mid thickening that gives the riff its huge controlled bottom end.
Workaround: Bass at 7.5 and Treble pulled to 5 approximates the low-mid lift the EQ provided.
The subtle eighth-note repeats on the opening figure are absent; the main riff is largely unaffected.
Workaround: Play the figure dry; the delay is barely present under the riff anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.