TOOL · settings for Epiphone Les Paul Standard + Yamaha THR10II
At zero: Effect · Echo/Reverb
No effects needed for this part.
Tool's Vicarious main riff on a THR10II: Hi Gain mode, bridge ProBucker, drop D. Mids pushed, low end tight, treble slightly dark. No pedals needed — the modeling gain replaces the boost, and the amp's delay stays off under the riff.
Less tightened pick attack and front-end push into the amp.
Workaround: Raise amp gain to 7 and middle to 7; pick harder near the bridge for attack.
Less low/low-mid thickening of the amp front end.
Workaround: Bass 5.5 with middle 7 approximates the low-mid lift within the THR's EQ.
No subtle eighth-note repeats on sparse figures.
Workaround: The THR's built-in delay can cover it, but keep it off under the main riff.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.