TOOL · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 High input cranked for a tight, mid-forward drop-D chug, bridge ProBucker, tone rolled back slightly to match the Diezel/Marshall blend's dark top. No pedals available, so gain comes from the preamp alone.
Without a front-end boost the riff loses tightness and some saturation.
Workaround: Push preamp to 8.5-9 on the High input and pick hard with firm palm muting.
Less low/low-mid thickening at the amp front end.
Workaround: Raise amp bass to 6-6.5 and middle to 6.5 to approximate the low-mid lift.
Opening figure lacks subtle repeats and depth.
Workaround: Play the riff dry; the delay is barely audible under the main riff anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings