TOOL · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Drop-D Vicarious rhythm on a DSL40CR: Ultra channel OD1, bridge ProBucker, mids pushed, tight bass with resonance moderate. Tone shift off to keep the midrange push. No boost pedal, so gain comes from the amp itself.
Less tightened attack and front-end push; palm mutes are slightly looser.
Workaround: Raise Ultra gain slightly and keep picking right at the bridge with firm palm muting.
Less low/low-mid thickness than the multi-amp blend.
Workaround: Use resonance at 6 and bass at 5 instead of scooping; leave tone shift off.
Opening figure loses a little depth; main riff is unaffected.
Workaround: Play the sustained notes with more ring-out; the riff was mostly dry anyway.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings