TOOL · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Keeps 5/4 chug gaps silent.
Level unity+2 dB, Treble +1, Bass flat.
+3 dB at 100 Hz, +2 dB at 250 Hz, -2 dB at 4 kHz, level unity.
Helix direct: Placater Dirty into a 4x12 IR for the Diezel/Marshall blend, with a Kinky Boost and EQ out front for tightness and low-mid girth, plus a low-mix eighth-note delay for the sparse intro figure.
Single amp block sounds narrower than the record's layered low end.
Workaround: Run a second amp block (Brit Plexi Brt) in parallel with the Placater, panned slightly, blended low.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets