TOOL · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with no pedals cannot reach Diezel VH4 saturation. Best available: bridge ProBucker into the Vibrato channel pushed loud for edge-of-breakup grind, mids faked by rolling tone and digging in. A high-gain pedal is essential for this riff.
Without a drive pedal the riff is clean-to-crunchy and loses all weight and sustain.
Workaround: Volume at 7+ on the Vibrato channel, bridge pickup full, pick hard for maximum breakup.
No low/low-mid thickening or front-end tightening of the riff.
Workaround: Middle at 8 and bass pulled back approximates the mid push on the Twen's scooped voicing.
Loses the subtle eighth-note depth on the opening figure.
Workaround: Play the figure with more sustain and let notes ring; amp reverb is the wrong texture here.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom Silverburst (bridge JB) → MXR M-133 Micro Amp → DOD FX40B Equalizer → Boss DD-3 Digital Delay → Signal splitter → Diezel VH4 blueface + 1976 Marshall Super Bass (+ Bogner/Rivera blend) → Mesa/Boogie 4x12 and Marshall 4x12 cabs, multi-miked
The notes are not technically hard, but holding the groove through the odd meters and keeping the muting consistent enough to match the recording's clarity is the real challenge.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings